GP test cyp 250 different colors?

**endurance724** · 10-26-2010, 08:12 PM

hey guys i have 2 vials of GP test cyp, both from a very reliable source. and i looked up both ISN numbers and they are authentic however, one is clear in color and the other is like a cloud colored, like milk poured into water. is this normal? anything i should b concerned about?

**Khoiktran** · 10-26-2010, 08:18 PM

Sounds like your gear crashed. You can add some BA (.5 cc) solution to it and reheat it. It should be ok after that.

**Buzzard** · 10-26-2010, 08:22 PM

Sounds crashed to me too. Ive had 6 10ml vials from GP and 2 of them crashed. I just lightly heated them up and they were GTG. I don't think that BA is necessary... IMO...

**endurance724** · 10-26-2010, 08:29 PM

how should i heat them? and what is meant by crashed?

**bccs** · 10-26-2010, 09:05 PM

Crashed means that it fell out of solution, this can happen if it gets cold. by warming it up you will increase the solubility of the test and it should go back into solution.

**endurance724** · 10-26-2010, 10:01 PM

how should i heat them up again?

**bccs** · 10-26-2010, 10:12 PM

I would try hot water, but not so hot that you cant touch it...once it is warmed up roll it between your hands gently to mix it...don't shake it

**OutWhey** · 10-27-2010, 01:51 AM

Originally Posted by endurance724

how should i heat them up again?

it has nothing to do with the gear being good or bad.

its like mixing koolaid.

heat it up, it may take a few times.

preheat to 250 degrees, then put in for 20 minutes.

then notice if it clears up. if it does, what happens when it cools. then report back.

BTW GP is good source will take your word for it, and should replace it.

OR

place in a pan with a little bit of water (.5") and heat the water and place the vial in the pan. Let it sit for a little while and swirl the gear around

**Buzzard** · 10-27-2010, 05:06 AM

OP... Here's how I did it. Take a coffee cup and add about enough water to go 3/4 up the height of your vial. Put the coffee cup with water in microwave until it starts to boil. Take it out and sit your crashed vial into the water for a few minutes. Then remove and swirl around. It may take 2-3 times. Try to keep it warm for a while. I think it's the quick temp change from hot to cold that causes the crash.

**endurance724** · 10-28-2010, 12:12 AM

awesome thanks for the help, i juss took a pot with a lil bit of water, and put it on the stove and put my vial inside, and warmed it up and watched the crystals dissappear.

**OrbitNutrition** · 10-28-2010, 12:14 AM

Exactly what you should have done, great to hear it went back to normal, crashed gear means its legit and full of test

just separating from the oils.

**Buzzard** · 10-28-2010, 08:34 AM

Originally Posted by endurance724

awesome thanks for the help, i juss took a pot with a lil bit of water, and put it on the stove and put my vial inside, and warmed it up and watched the crystals dissappear.

NP, Bro... One suggestion though. Heating it the way you did gets it a bit hotter than how I did, so I'd suggest putting a pin in the stopper to 'vent'. Otherwise you could blow the top off of your vial and lose those precious gears. That would be a major jerkedness foul.

Thread: GP test cyp 250 different colors?

Thread Tools

Display