Thread: trouble with suspension

what size pin? Sometimes anything smaller than 23g, can be problems. I have used 18g for suspension before.

using a 23g pin. should i get a bigger size? i thought cause it was water based i could use a smaller gauge

with suspension you're gonna have to go with a bigger gauge like 18-20, the particles tend to get stuck in the needle otherwise when drawing or injecting. i know some people who warm theirs up before drawing and pinning, i havent tried this with suspension however so i cant say how effective it would be at maybe getting the solution dissolved a little more before it re-crystalizes

thanks for the response.. i'll try a bigger pin.

So you have to shoot with that big ass pin too?

from my experience with suspension, when it clogs pin large as 23g, your are in for some major pain after injection.

i have managed to shoot for the past couple days, with alot of work and unfortionantly a little bit of waste. and i have been sore but nothing to bad. its just been realy frustrating trying to get this shit into the damn syringe

Damn, I can't imagine pinning with 18g. That shits almost as big as a straw I use to drink my kool aid

Originally Posted by Vibrant

Damn, I can't imagine pinning with 18g. That shits almost as big as a straw I use to drink my kool aid

Yup, I pinned each cheek eod, before getting brave enough to try other sites. Every pin w/ an 18g. Yes it sucked. Gains were great though.

22g will likely work.

^ what the fuck are you teaching these kids?! do not....use a 18 gauge pin to inject! it really bugs me when people dont realize what they are doing and teach people the wrong things. you will be fine with a 23 g pin. let me explain why.

depending who made your suspension will dictate how large the test crystals are, thats why you are having trouble pulling the test into the syringe. ALSO! the brand of syringe will make a big difference...ive always sweared on bd, but not for water based test, buy Terumo those 23g v.s. a bd 23 are waaaaaaaaaay better,if you dont feel like getting a 18g pin to with draw the test and your still having issues getting it out, follow these directions...

inset needle into the vial (assuming its a 10ml vial)
inject air into vial (.5cc or what ever your dose is gunna be)
pull plunger to remove test.
if test is not coming out or is barley trickling out, then pull plunger back to the max out zone, release and let it snap back, repeat that about 8-10 times (or how ever long you need untill you get the desired test out)
change needles
point needle down, pull back on plunger slowly allowing air bubbles to mix the suspension in the syringe.
and enjoy.
.....if your not a injection ninja and you go to slow the cyrstals will harden and make wall in the needle. to help prevent that, also ad .5cc-1cc of a b vitamin i prefer b complex over b 12...but either one is fine.

All who use Aquabolic Asia Pharma, never have that problems! But who use Agoviron depot by Biotika ALWAYS have big problems to inject it.

Originally Posted by World-Pharma.org

All who use Aquabolic Asia Pharma, never have that problems! But who use Agoviron depot by Biotika ALWAYS have big problems to inject it.

^This!