Often people pay an arm and a leg for filtered oil. Somewhere in the realm of 17$ for
100ml.This is insane as its very cheap to buy. You can buy a couple liters of safflower oil
or grapeseed oil from your local grocery store and filter it yourself.
Lets start with 1000ml just to get the idea.
You will need:
1000ml, your oil of choice
1x Millipore 22um stericup filter and receiver cup combo. * You will also need a hand pump
1x septa top
1. Setup your filter by attaching pump and filling the top with 1000ml oil.
2. Give the pump a few squeezes untill the PSI guage reades 8.5-9 (no higher).
3. Every few min squeeze a few more times to keep pressure at 8.5-9 PSI.
4. When all the oil has been filtered carefully remove septa top from packaging and carefully replace the filter on top of the receiver with the septa top being careful not to infect the bottle.
The septa top has a silicon stopper that allows a needle to pass through and you to draw oil from it in smaller than 1000ml increments.
You can add 10ml of BA if you want but there is not really any need unless you plan on injecting the oil straight from the flask. For example, you are cutting a bottle of prop shot by shot. (not recommended)
Usually you will be filtering the oil again so the BA can be added then.
I say 10 ml BA so that you can add another 10ml when preparing an injectable =2%
You can usually run 3000 ml easy through a filter and even more if you use a prefilter.
There is usually not a reason to produce more than 1k sterile oil at a time.
No you do not need to heat it. A 22um pore filter wont let anything through. It shouldnt take more than 2-5 min.
Good luck
B
All information provided by me is for research purpose only. I do not sell illegal compounds nor can I supply anyone with a source for raw materials.
DISCLAIMER:
All health, fitness, diet, nutrition & supplement information presented on IronMagazineForums.com's pages is intended as an educational resource and is not intended as a substitute for proper medical advice. We do not condone the use of anabolic steroids (AAS), all information about AAS is for educational and entertainment purposes only. Consult your physician or health care professional before performing any of the exercises, or following any diet, nutrition or supplement advice described on this website. As well as any exercise technique or regimen, diet, supplement, etc., particularly if you are pregnant or nursing, or if you are elderly or have chronic or recurring medical conditions. Discontinue any exercise that causes you pain or severe discomfort and consult a medical expert. The statements made about products have not been evaluated by the Food and Drug Administration (U.S.). They are not intended to diagnose, treat, cure or prevent any condition or disease. Please consult with your own physician or health care practitioner regarding the suggestions and recommendations made at IronMagazineForums.com. Neither the author of the information, nor the producer, nor distributors of such information make any warranty of any kind in regard to the content of the information presented on this website. Except as specifically stated on this site, neither IronMagazineForums.com, nor any of its authors or other representatives will be liable for damages arising out of, or in connection with the use of this site. This is a comprehensive limitation of liability that applies to all damages of any kind, including (without limitation) compensatory, direct, indirect or consequential damages, loss of data, income or profit, loss of or damage to property and claims of third parties. Sponsors pay for advertising space, we have no affiliation with the companies that have banners displayed on our websites. Please be advised it is your responsibility to check the laws that govern your country, state, or province in regards to items offered by some companies you may read about on this site.