Thread: Clearskypharmacy

I have,
everything went perfect in the beging but after awhile I noticed my swivel bracket would not fuction as well as the qute valve and had to get a re-alighment in both t-1 and t-16 roto cuff sections in both sections 4 and 6. #4 is normal from what i have heard but everyone i have talked to said there is no excuss for # six being out of adjustment like that. I am so confussed on what to do.

Originally Posted by Pork Chop

I have,
everything went perfect in the beging but after awhile I noticed my swivel bracket would not fuction as well as the qute valve and had to get a re-alighment in both t-1 and t-16 roto cuff sections in both sections 4 and 6. #4 is normal from what i have heard but everyone i have talked to said there is no excuss for # six being out of adjustment like that. I am so confussed on what to do.

I found your problem first you have to find the source, once you do
you will realize you can't check it. Like the manual says. But yea it suz your
# 6 is out of adjustment!

Originally Posted by johnniejr243

I found your problem first you have to find the source, once you do
you will realize you can't check it. Like the manual says. But yea it suz your
# 6 is out of adjustment!

doc said i worked the wrong socket and caused a minor melt down in the middle of the adjustment cycle/ re-laps period, which i knew nothing about. the manual did not give any indaction of this nor did it have a problem shooting section in case this were to happen. i dont know what to do at this point my freind..???

should i have it removed or just let it contuion to grow at this fast rate?