Thread: Homebrew Question

What solvent/s are you using and what mg/ml are you trying to attain? pm me if you want...

Did you mix the hormone with the solvents first? If so did that go into solution? We need some more info. More specifically what solvents, dose and how much you were making.

Like said above, need more details. How much total were u brewing?

I was brewing 10 grams @ 250mg and 5%BA.... I did not mix hormone with solvent first.....Think that may have been my issue?

Please list your complet breakdown of ingredients and the amt. usually best to heat hormone and solvent together until dissolved. Then add oil and reheat. I'm sure yours had lots of swirl in it.

Originally Posted by 2lt2wt

I was brewing 10 grams @ 250mg and 5%BA.... I did not mix hormone with solvent first.....Think that may have been my issue?

With te, you must mix hormone and solvent first... little tip, use it if you like...2%ba and bb(enough to dissolve te..usually10-12% range is better, health wise)..ba over 3% starts getting into the gray area of safety, and over 5% can start getting necrotic to tissue at inj site.....

2% BA is all that is needed. I put the BA and then I normally use 20% BB and I put both of those in a beaker. Then add the hormone. While you are doing this, put a few inches of water in a pan and heat it over medium heat. Then swirl your mixture around until it is dissolved as much as possible. Then stick it in the warm water and heat it up. Keep swirling until everything is dissolved then pour in your GSO and filter.

I'm going to try it again....thanks for all the input....SWIRLS were a big problem...live and learn

Originally Posted by SloppyJ

2% BA is all that is needed. I put the BA and then I normally use 20% BB and I put both of those in a beaker. Then add the hormone. While you are doing this, put a few inches of water in a pan and heat it over medium heat. Then swirl your mixture around until it is dissolved as much as possible. Then stick it in the warm water and heat it up. Keep swirling until everything is dissolved then pour in your GSO and filter.

I've never used BB when making my enanthate.....i'm assuming, you recommend it?!?

Enanthate is super easy to brew and doesn't require any BB. You can add some and it'll help thin it out, which is a good thing if you use 25g+ needles. It isn't a requirement but usually brewers just use a standard formula. Most use 2/20/gso or 2/20/gso/eo (difficult shit like prop).