I am tying an experiment to create a transdermal fina. I understand the process of breaking down the pellets in Heet, filter and stripping the ester with lye, flushing, etc. However, I am at a loss as to the quantities of lye solution to strip off the esters.
If I use 6 oz of Heet for 2 carts of Fina, what will I need in terms of a solution of lye (consentration and amount)?
I have also read that stripping off the ester is not needed, in which case I will just disolve in Heet, filter and dry.
Any feedback would be appreciated.
Posted by: Pirate!
I don't think you find the answer in the supplement forum.
Posted by: dg806
Yo have fina and test confused.
Posted by: Phred
I thought I had (or maybe it is better say "should") cleave the ester from the Fina. I would be using pellets (Finaplix-H). So the Heet (MA) is to breakdown and seperate the binders. My understanding is the ester is still in the solution and the lye would cleave the ester (the fina would crystalize out of the solution).
I have also read once dissolved in the MA, you can filter and just let the MA evaporate. Then add the remaining dried powder to a transdermal solution.
Posted by: dg806
Fina comes out as an acetate.
Posted by: dg806
You can get Fina enanthate, but it is made from powder, not pellets.
Posted by: Phred
OK. I understand it better now. I was looking at a lot of different sources and some were using powders in lieu of pellets and I was confusing the process for each as being the same or similar. Thx.