-->
Pages: 1

Conversion??


(Click here to view the original thread with full colors/images)



Posted by: devildog88

What does 1cc equal? Is it different depending on the gear you shoot?


Posted by: TJ Cline

Yes, the lable will say the dose.....so if it's 200mg then it's 200mg per cc or ml


Posted by: devildog88

Ahhhhhh, so how do you mix the AAS in the same syringe?


Posted by: TJ Cline

I just draw one to the cc amount I want...say 1 cc test then draw again from the other container...say 1cc Deca.....then put on a fresh needle for the injuction.


Posted by: Stu

Quote:
Originally Posted by devildog88
Ahhhhhh, so how do you mix the AAS in the same syringe?
you dont mix it, it comes disolved in oil at a certain concentration.


Posted by: devildog88

So when you heat the oil do you use hot water? How do you know when it is warm enough?


Posted by: Witmaster

Ok, so... are you cooking your own? Get a bunsen Burner and proper vials for acurate temp control.


Posted by: devildog88

No, I don't know enough to cook my own. I am a history teacher for christ's sake! I was just wondering about heating the oil before you shoot it.


Posted by: largepkg

Quote:
Originally Posted by devildog88
No, I don't know enough to cook my own. I am a history teacher for christ's sake! I was just wondering about heating the oil before you shoot it.
I just run the syringe under the hot water for 60 seconds. Don't over think this step, it's not rocket science!


Posted by: Witmaster

Ahhhh Some people use warm water (VERY mild temp increase) Most just shoot at room temp.


Posted by: Pirate!

You only need to heat it if you have a very narrow needle, like 25 gauge.


Posted by: kicka19

i didnt heat it last time and took like 1 minute to get 1ml, deff heating it next time, and ya i was using 25g


Posted by: Tough Old Man

Quote:
Originally Posted by Witmaster
Ok, so... are you cooking your own? Get a bunsen Burner and proper vials for acurate temp control.
You don't need all that brother. Just heat a pan of water to a simmer and turn it off. Then place your vial in the hot water for 15 min's. Done


Posted by: gococksDJS

My last cycle I had to push 2.5ml's through a 25g needle and that took way to long, so I switched to a smaller pin. And if you're trying to heat the oil before injection, why not just hold the syringe under some warm running water? No need to bust out the Betty Crocker beginners kit.


Posted by: Mudge

1cc = 1 cubic centimeter = 1 milliliter, those are measurements of volume they never change.


Posted by: ag-guys

Quote:
Originally Posted by ForemanRules
Yes, the lable will say the dose.....so if it's 200mg then it's 200mg per cc or ml
bump

AG
www.ag-guys.com


Posted by: Tough Old Man

Quote:
Originally Posted by gococksDJS
No need to bust out the Betty Crocker beginners kit.
Damn your getting good son



(Click here to view the original thread with full colors/images)





vBulletin Copyright ©2000 - 2008, Jelsoft Enterprises Limited.


Content Relevant URLs by vBSEO 3.1.0

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38