Here is my setup. My issue is that the oil is not filtering to the bottom... The Pump works.
It is either the seal where the blue nozzle attaches to the stericup...OR there might have been a cover on the filter inside the top cup. See the picture? I didn't touch the inside because I wanted to keep it as sterile as possible. Did I fail big time?
its probably the blue nozzle, just push it in very carefully. I get this problem some times with stericup.
If I push to hard it will start to leak on the sides.
Thank's. I couldn't figure it out.
I ended up throwing it out. I baked it at 275 for 20 minutes instead.
Just so you know, baking it like that that wont sterilize it at all..
What makes you say that unlikely?
The temperature I mentioned is actually too hot. Pasteurization would have been the preferred method.
Put the vial in water that is 150?F - 170?F for 30 minutes.
AT LEAST THIS IS WHAT MY RESEARCH HAS PRODUCED. Let me know what you think.
I wouldnt even think of injecting unfiltered gear. Any impurities and large chunks will just be transferred over. Gear should never be baked, ever. It should only be filtered