Maybe the title is wrong but i see a lot of mixes and I love my test prop and i love my tren and I dont mind stabbing myself at all but I love a good 100mg prop to 75mg tren a mix. anyone got a good link to how to mix that up do you just add both the powders to the ba bb asuming you will have to up the percentages a bit?
what would u say 50% E.O 50% oil?
honestly brother if i said yes i would just be guessing. i rather tell you im not sure than tell you the wrong shit. Im sure Brundel will see this and comment on it. Im intersted in knowing my self. Im going to be working on a tne/trem blend very very soon and the blen you mentioned sounds very tasty as well. might have to give that one a shot too
hmm tne that i would also love to know how to blend that
We love our tren lol
yes i understand its only test base but from what i understand its a bitch to get to hold and yea if you got a tasty recipe a brotha would be much obliged and any cycle with tren is not really a cycle at all :P
I've been searching for a very long time for this type of brewing and have not found anything so far...
OP....try it and report back to use after you pin your blend
no shit? thats cool. just got my test base so ill be blending tne/tren.
With something like prop or tren ace you could go 50/50mg with 2%BA and 20%BB.
Any higher and more solvents will have to be employed to keep it from crashing.
You could likely go 75/75 if you use EO as your oil.
You could likely go 100/100 if you go EO 20%guiaicol 20% BB 2% BA.( I have not done this myself.)
I have never done this so Im gonna give you the recipe I would use as an attempt.
Im 99% certain this will work perfectly. I have no reason to think otherwise. The 1% is merely because I have not in fact done this myself.
20ml-50/50 TNE/TREN ace
7ml Ethyl oleate
1g Tren ace.
if you put that in a powder calculator do you just put the dosage at 400???
**Recently made a TE 250/Npp 150 blend. It held well with a ba/bb of 2/18.**
sorry im new to this brewing thing and trying to figure out exaclly where you get all yournumbers. I have read things on basskiller for how to make it but i am interested in knowing the calculations and how you get there
I think 50/50 TNE/Tren ace is a pretty tough shot...you must be a bulldog to want it higher.
75/75 Might hold yes.
You can always test it out and if it crashed heat it up add some more of the EO/solvent mix and refilter.
yea thats what i was going to do. 10ml tester.
but a guy posted Recently made a TE 250/Npp 150 blend. It held well with a ba/bb of 2/18. I was thining if a person was looking at making that and wanted to use a powder calculator would just just put the dosage in the calculator as 400 (250+150)? Please ignore my ignorance
how do you decide on the ammount of ba and bb some people us 5 the above example uses 2 i think yours had 8?
It depends on the hormones and dosage.
A very commonly used % or ratio is 2% BA and 20% BB. This is common because it will hold a wide variety of hormones and dosages. It will not hold most unesterified hormones.
For the calculator:
2% = .02
is that why you raised it to 4 and 40 for the tne is that common for unesterfied?