Last edited:
-
🛑Hello, this board in now turned off and no new posting.
Please REGISTER at Anabolic Steroid Forums, and become a member of our NEW community! 💪 -
🔥Check Out Muscle Gelz HEAL® - A Topical Peptide Repair Formula with BPC-157 & TB-500! 🏥
Best Of Stickies
- Thread starter ZECH
- Start date
- Status
Half Lives Ect Ect
See also: this article
Bill Roberts, PhD. Anabolic Steroid Esters: comparison of ester length, lipid solubility, dosing, and anabolic/androgenic ratios.
See also: this article
Bill Roberts, PhD. Anabolic Steroid Esters: comparison of ester length, lipid solubility, dosing, and anabolic/androgenic ratios.
Last edited by a moderator:
Courtesy of Pirate!.............
GYNECOMASTIA: ETIOLOGY, DIAGNOSIS, AND TREATMENT
http://www.endotext.org/male/male14/maleframe14.htm
GYNECOMASTIA: ETIOLOGY, DIAGNOSIS, AND TREATMENT
http://www.endotext.org/male/male14/maleframe14.htm
Courtesy of Kitchen Chemist
Powders and what % of solvents they will dissolve in:
--------------------------------------------------------------------------------
From personal experience, 3%ba and 15%bb will dissolve and keep the following in solution
Put all liquids together (oil/solvent) and heat in pot of water, shaking everyone once and awhile til oil is clear, and powder is completely dissolved. Once made up, filtered and put in vials, put in oven at 250 F for 45 minutes.
test enan 275mg/ml
test cypionate 275mg/ml
test prop 100mg/ml
tren acetate 100mg/ml
masteron 100mg/ml
boldenone propionate 100mg/ml
nandrolone phenylpropionate 100mg/ml
nandrolone decanoate 275mg/ml
boldenone undeclynate 300mg/ml
liquids that dissolve in everclear
clomid 50mg/ml
nolva 50mg/ml
liquids that dissolve in propylene glycol
arimidex 1mg/ml
femara 2.5mg/ml
finastride 5mg/ml
clen 200mcg/ml
Cialis will dissolve in PEG-400 at 30mg/ml
__________________
Powders and what % of solvents they will dissolve in:
--------------------------------------------------------------------------------
From personal experience, 3%ba and 15%bb will dissolve and keep the following in solution
Put all liquids together (oil/solvent) and heat in pot of water, shaking everyone once and awhile til oil is clear, and powder is completely dissolved. Once made up, filtered and put in vials, put in oven at 250 F for 45 minutes.
test enan 275mg/ml
test cypionate 275mg/ml
test prop 100mg/ml
tren acetate 100mg/ml
masteron 100mg/ml
boldenone propionate 100mg/ml
nandrolone phenylpropionate 100mg/ml
nandrolone decanoate 275mg/ml
boldenone undeclynate 300mg/ml
liquids that dissolve in everclear
clomid 50mg/ml
nolva 50mg/ml
liquids that dissolve in propylene glycol
arimidex 1mg/ml
femara 2.5mg/ml
finastride 5mg/ml
clen 200mcg/ml
Cialis will dissolve in PEG-400 at 30mg/ml
__________________
MIXING HCG
Break open both amps. Then with a 25g pin, draw up the 1ml of 'solvent' (which is bacteriostatic water) and inject into the amp with powder. It will mix to a clear solution. Draw this solution up with the same 25g pin and inject into a sterile vial. Be sure to wipe the top of the sterile vial with an alcohol pad first.
Now draw 4 ml of bacteriostatic water (again wiping the top of the bacteriostatic water vial with a alcohol pad before drawing) and inject into the sterile vial. You will now have a 1ml = 1000iu solution. Use slin pins and inject sub-q. With this concentration, 25 on the slin pin equals 250iu's, 50 equals 500iu's etc.
Refrigerate the vial and use as needed. It will last reconsituted for 60 days.
Note: Injected subcutaneous at the navel
Break open both amps. Then with a 25g pin, draw up the 1ml of 'solvent' (which is bacteriostatic water) and inject into the amp with powder. It will mix to a clear solution. Draw this solution up with the same 25g pin and inject into a sterile vial. Be sure to wipe the top of the sterile vial with an alcohol pad first.
Now draw 4 ml of bacteriostatic water (again wiping the top of the bacteriostatic water vial with a alcohol pad before drawing) and inject into the sterile vial. You will now have a 1ml = 1000iu solution. Use slin pins and inject sub-q. With this concentration, 25 on the slin pin equals 250iu's, 50 equals 500iu's etc.
Refrigerate the vial and use as needed. It will last reconsituted for 60 days.
Note: Injected subcutaneous at the navel
Last edited:
- Status