• Please REGISTER at Anabolic Steroid Forums, and become a member of our NEW community!

powder mixing

castlehill

Registered
Joined
Aug 30, 2010
Messages
131
Reaction score
8
Points
0
Location
Texas
I was curious about this. Recipe's for test 250mg/ml are easy but can you adjust the mixture to make it 500mg/ml without it causing any problems? I was thinking about ways to just reduce the volume because 1.5-2ml is a lot to inject.
 
I was curious about this. Recipe's for test 250mg/ml are easy but can you adjust the mixture to make it 500mg/ml without it causing any problems? I was thinking about ways to just reduce the volume because 1.5-2ml is a lot to inject.

For dosages that high you will need to use EO and Guaiacol.
GSO or CSO will not hold that high a dose without crashing.

Keep reading the conversion recipes in the homebrew section, you'll find what you're looking for.

At 500mg injection per week, you would split into two 250mg doses (pin 1/2 ml 2x/week).
At 1 gram per week you would double the above doses.
 
For dosages that high you will need to use EO and Guaiacol.
GSO or CSO will not hold that high a dose without crashing.

Keep reading the conversion recipes in the homebrew section, you'll find what you're looking for.

At 500mg injection per week, you would split into two 250mg doses (pin 1/2 ml 2x/week).
At 1 gram per week you would double the above doses.

I will look for that recipe thanks,
I was looking to cut it to a half ml X 2 a week, if I could add tren/mast or whatever else and keep the dose around a ml it would be good. I rotate injection sites and don't like to do more than a ml in my shoulder.
 
Back
Top