Test E pain

[Hungry]

Hey what's up brothers? I forgot my password for my old account, so I'm not new here .. I need some advice.My rat is currently on a cycle of Test E and Tren E .. I can't say where it's from because its local.
Well anyways here's the thing he's on his second week.. The tren pins are painless, but the test e shots hurt like a mug. I think the test might be garbage. The pain starts a few min after pinning feels like a knot and a little warm . The worst pain comes when sitting.Well this is not his first cycle.This is actually his fourth, but it's his first time using ugl.My rat has regretted this cycle, and wants to abandon the whole thing. How should he run his pct? Dosage etc.. The reason I ask is because its only been two weeks.
Well next time ill stick with gmp other than local crap. Lesson learn ..

 

[overburdened]

test e can have any number of reasons it hurts.. contaminants in the raw,or the oil... 'reactants' left in the test e(from manufacturing it....the esters are organic acids to begin with, so you could have some pain from a unreacted carboxylic acid group in the raw powder.... I've seen test e that has melted, and taken the plastic bag it was in with it....(as in, it melted the bag, and the bag became part of the test e at that point)... Tren e is quite a bit different in it's physical properties than test e, so there usually isn't this issue with some compounds with the enanthate ester(even though they have the same ester, they are FAR different, in matters of physical properties, than test e...) tren e is a powder, test e is a 'waxy type' compound... I would venture to guess the test e raws the UGL used are not up to pharma grade, and have unreacted acid in it still... thus the acid is in your oil! This could cause some pretty severe pip, among many other things!

 

[supaman23]

The only thing you can do, if you want to go through the hassle, is to get a sterile syringe filter .22um and filter the test e into an empty sterile vial. If that doesn't fix it, might as well throw it away.

 

[overburdened]

The only thing you can do, if you want to go through the hassle, is to get a sterile syringe filter .22um and filter the test e into an empty sterile vial. If that doesn't fix it, might as well throw it away.

this will not remove contaminants such as carboxylic acids, that were in the raws to begin with.... More than likely, that is what is causing the pain.

What mg is the test e? How long(how many cycles) have you been running aas?

 

[Hungry]

250
4cycles
By choice .. Toss the product
It's not worth it. In my opinion ..
Hurting more today .. Can't even bend without pain..
My question is how to recover .. PCT wise ..

 

[Nok]

i dont think you even need PCT. your body's natural testosterone isn't shut down. i would venture to say it is not even suppressed any yet.

but don't quote me.

 

[overburdened]

250
4cycles
By choice .. Toss the product
It's not worth it. In my opinion ..
Hurting more today .. Can't even bend without pain..
My question is how to recover .. PCT wise ..

Run a full pct... you were using tren, so you are probably fully suppressed already. You have run four cycles, so you should have a good idea what pct works for you best... If you hadn't run the tren with the test, I would say you probably could just run a really light pct... but the tren probably shut you down completely

 

[Hungry]

Thanks for the info guys.
Little update started developing a ball around the area .. It was warm to touch, but didn't looked infected.The ball has gotten smaller in past few days, and the pain is going away. I think it was bad raws IMO.