Using GSO to cut Test E questions?

[mr.magoo]

I have had multiple problems with IM injections of Test E. Two different suppliers in recent past.

I am running 200mg/week...split to 2 injects per week.
(TRT level)

This is not much compared to what others are injecting, but my response to either the BA or possibly EO? are driving me to seek using Sterile USP GSO(purchased online from pharma supply company) to cut my gear. Both suppliers were 250mg/ml...standard mix.


I have 3 questions.
1. What is minimum effective ratio of GSO I can used to cut the Test E?
(New order of Test E will to arrive in next few days)
I have heard of possible 1:.5 ratio - Test E to GSO
I have also seen 1:1 ratio.
Will the lower ratio work?

2. Second question: Can I mix and store all at one time? or does this
need to be done per each injection?

3. Can this mix be taken sub-q? (There are recent studies and thread on taking sub-q Test-E injections effectively)

 

[KUVinny]

What kind of reactions have you been having?

What gauge and length needle are you using?

There is no set ratio. Since you are only doing about .4 ml per you can just draw to fill to 1 ml and that would be fine.

I would not even contemplate doing it sub q at this point.

 

[mr.magoo]

What kind of reactions have you been having?
-Swollen sore areas, worst one ended up in ER for abcess to be drained directly from quad.
-Multiple issues to get location correct, missing, or getting in between muscles, etc.
- All of issues seem to be both user error on injections as well as reaction to product, either the BA or EO.
- Fortunately at the lower doseages I am running for TRT, there is wide body of experience and evidence that sub-Q injections are effective. Look up posting by Heavy Iron where he ran a log of doing subQ daily to track effectiveness.

What gauge and length needle are you using?
I have used 23 gauge 1.5 inch
I have used 25 gauge 1.0 inch
For subQ I will probably use 27 gauge 1/2"

There is no set ratio. Since you are only doing about .4 ml per you can just draw to fill to 1 ml and that would be fine.
My desire is to use lowest possible amount of GSO to cut the Test E,
and still be effective in combating the aftereffects I have continued to get from injections. I have read from people posting that GSO can be used at half the volume of Test to cut it effectively. I have read others that suggest a full 1:1 ratio. Hoping some folks that cut their gear with GSO might have suggestions.

I would not even contemplate doing it sub q at this point.
-I disagree, as I have pretty much had it with attempting to do self IM's.
I have done hundreds of subQ for HGH, and HCG with no issues at all.
And IM injections is not necessary for dosages I am running. I would probably to something like a 3x or 4x/week schedule to keep volume lower, and hope to maintain consistent levels of Test in my system

 

[bulldogz]

If I have injection pain or PIP I usually use .5ml of filtered GSO to 1ml of gear..so I shot 1.5ml in total...some do use the 1:1 ratio...1ml of GSO to 1ml of gear...

I think like you said your whole technic of pinning is bad...get on you tube and look up vids....

Check this one out: http://www.ironmagazineforums.com/anabolic-zone/146928-how-inject-testosterone.html#post2537786

 

[bigbenj]

Is your test from a legit pharmacy, or an online supplier?

Sounds like you either received dirty gear or used improper techniques.

 

[mr.magoo]

My gear is from online sponsors UGL...well known sponsors.
So, not same as prescription. 250mg/ml.

I am certain I need to cut the gear, as I am reacting to it too much.

I will research pinning methods further...hospital trip spooked me a bit.

Thanks!