• Hello, this board in now turned off and no new posting.
    Please REGISTER at Anabolic Steroid Forums, and become a member of our NEW community!
  • Check Out IronMag Labs® KSM-66 Max - Recovery and Anabolic Growth Complex

USP Ethyl Oleate

joedel

Registered
Joined
Dec 7, 2011
Messages
92
Reaction score
3
Points
0
Location
ny
anyone use these for home brews?

is it possible to suspend enths in this "oil" if a proper ratio is used ... sayyy 50:50 with filtered grapeseed?

much thanks bros
 
Enths as in test e? U don't need to waste money on EO for test e which suspends in just oil and some BA.

But yea, EO is a great suspender of pesky raws like test prop where u can go 50:50 oil:EO. Reduces pain significantly I hear and thins out the final product very well so it flows through slin pins easily.
 
yea i know you dont need it, but since when on cycle i have so much to pin i like to rotate to smaller muscle groups like bi's pecs traps ect..... so for those i like to use 25g so was wondering if it would make it thinner to flow easyer u know what i mean bro?
 
i like to wait full week- week an a half before putting more oil into a muscle group
 
Yes EO makes things flow much easier.
 
yea i know you dont need it, but since when on cycle i have so much to pin i like to rotate to smaller muscle groups like bi's pecs traps ect..... so for those i like to use 25g so was wondering if it would make it thinner to flow easyer u know what i mean bro?

I always use a 25g. Grapeseed oil, 18% BB, and 2% BA in all my brews, never have had an issue. Can't push the plunger all that fast but takes 60sec tops to do a 3ml shot.
 
I would use the EO in higher mg/ml brews but for the rest 100% GSO...

That's if you're not allergic to EO..
 
good point, sust gave me some nasty knots but i figured it was prop since i read some things on prop doing that. does that happen w eo?
 
EO based blends have a tendency of going in smoother with less post injection pain (PIP). Usually half EO, half GSO does the trick and full EO is just costly over-compensation.
 
Muscle Gelz Transdermals
IronMag Labs Prohormones
Some people are allergic to EO meaning it causes u massive discomfort during and post injection.
 
so if u dont notice it until the next day than its not an allergic reaction.
 
EO makes the final product much thinner and easier to inject through a smaller sized needle.
But use EO for fast acting compounds like Test P, Tren A etc.. it should be painless 50/50 with GSO
 
On a side note, other than the melting points of compounds, is there any other way to tests powders for being legit ?
 
It's either the ester itself or the EO. I get knots from prop, but i can still walk when i pin my glutes.
 
Back
Top