Perfect way to heat up your gear.

[Ravager]

Warming up the oils makes it alot easier to draw and inject. I have something like this that heated it up good in a a few minutes....
Flower Factory candle warmer electric Product Page

I just sat the vials on there, and before I knew it they were nice n toasty. It drew about 10x faster thru my 25gauge.

 

[Himik]

You can also just set them in warm water.

 

[Woodrow1]

hot water works pretty damn good

 

[jimm]

yeah hot water or gtfo hahaha...

 

[Work IN Progress]

I put mine in a heating pad GYCH

 

[TGB1987]

I put mine in a heating pad GYCH

This is what I do too. I think the candle warmer would be a great idea. I may try this next time. Doesn't it get too hot though? I will mess around with it an see what happens.

 

[Ravager]

This is what I do too. I think the candle warmer would be a great idea. I may try this next time. Doesn't it get too hot though? I will mess around with it an see what happens.

It gets very hot, I've heard of people baking their gear so I'm not sure if its bad for the gear. OF course you don't need to leave it on there for too long I did about 5 minutes and it was nice n warm and thin.

 

[Dustdatarse]

I put mine in a heating pad GYCH

Same here, wrap that bitch up like a burrito and let it sit for 5-7 min, nice and hot.

 

[Mooksman]

laptop fan... WINNING

 

[jimm]

laptop fan... WINNING

yeah man why not put it in the oven with your pizza?

 

[keith1569]

ha thats a pretty good idea!

 

[SloppyJ]

Draw with a bigger pin and run it under hot water.... works for me.

 

[Mooksman]

yeah man why not put it in the oven with your pizza?

great comparison

 

[minimal]

do you guys always heat up ur gear when pinning?

 

[Mudge]

If you're drawing through a 25g, no wonder you're frustrated! I like 20s for pull, and 23/25 for push.

For stuff that used to crash a little, I'd warm up some coffee temp water in a cup and put in my vial afterwards, and shake occasionally to break it up. Maybe a warm injection would be nice though, but be damn careful with the temps!

 

[TGB1987]

I like my oil to be warm but you just don't want it to be too hot. I heat up all oils before injects but lately I have been injecting Winny with my Test so I haven't heated the oil at all since I am mixing it with a water based steroid.

 

[vortex]

Will ampules hold up to heating?

 

[Mudge]

Reasonable heating of course, you wouldn't inject 130 degree stuff, and amps wont blow up anywhere near 130.