the only and i mean only bad thing for me about this stuff is what is a dose i understand a pump is a dose but evey pump a little diff if i do a big pump i get big dose little pump.so diff amounts each time i pump it would be good if we could see a pic of a dose size like is it the size of a pea a nickel a apple etc what?
a pump = 1 full top to bottom pump. This equates to 1ml.
The pump can only draw so much into it and expell so much at a time.
I measured it. Its 1ml.
In each ML there is 50mg formestane.
The absorption rate can only be estimated. This is based upon a few factors.
Your skin
moisture
oiliness of the skin
The transdermal carrier
the compound.
In this case the carrier is as good as It can be...Pharmaceutical compounding pharmacies use a cream and its nowhere as efficient.
Black Lion uses a similar vehicle to androgel. But we added a couple things to assist absorption.
The compound formestane is a very tough one.
This is because although the actual molecules are relatively small they are very non soluble.
Formestane will not break down in 100% ethyl alcohol.
So...only a part of it is in solution and some in suspension. This is why you see a residue after you apply.
Not to worry. There is more than enough in solution to get to the desired result.
We can assume between 30-50% potentially higher depending on if you have well hydrated skin. Drink lots of water...(if your one of us you should be drinking a gallon a day anyways) and apply after a shower for best results.