Pulsated Pec
Registered
ive been using these my entire cycle and had no problems seems to work fine whats up with that pinning sust and eq with em
-
Hello, this board in now turned off and no new posting.
Please REGISTER at Anabolic Steroid Forums, and become a member of our NEW community!
-
Check Out IronMag Labs® KSM-66 Max - Recovery and Anabolic Growth Complex
28 gauge insulin needles
- Thread starter Pulsated Pec
- Start date
why are you using 29 gauge insulin needles for sust, and Eq???? No way Eq will go through that, Why are you not using 23, 24, 25, gauge 3mls?
Pulsated Pec
Registered
im using 28 gauge and been pinning it into my quad seems fine
Machine455
Registered
I agree The oil base is way to viscious to pass through such a small gauge. I tried once using slin needles with winstrol, and all it did was pull up water and left the crystals in the bottle. I always use 23 0f 22 gauge needles when i injest oil based comounds.
Pulsated Pec
Registered
but its not wasting my gear is the question because i have been doing it for the last 8 weeks and i flex when i pin and stick it all the way into the muscle of my quad and i do glutes with the test
Pulsated Pec
Registered
ok thanks yea i am switching to 25's tomorrow
I used a slin pin for a delt and a bicep shot at the beginning of my cycle just to experiment. Loading took forever but everything went smooth. I'm using axio test E so it's oil based but if it's anyone's familiar with it it's suspended in clear liquid and has a smoother viscosity than other Test E's I've seen.
Op don't sweat it.
I use 27g half inch pins for quads chest delts.
Can push throw Deca/Test E/P/S and EQ even all at once.
Also most injections are around 3ml range.
I stopped using 25g as if the needle was all the way in i would get a lot of pain injecting.
27g pop in and out with barley any pain.
And leave minimal scare tissue.
6 hours and the mark is gone.
I use 27g half inch pins for quads chest delts.
Can push throw Deca/Test E/P/S and EQ even all at once.
Also most injections are around 3ml range.
I stopped using 25g as if the needle was all the way in i would get a lot of pain injecting.
27g pop in and out with barley any pain.
And leave minimal scare tissue.
6 hours and the mark is gone.
lol no.
Just a normal 3ml syringe with 27G needles that attach to them.
Can go all the way from 18g to 30g.
You can interchange pins.
Draw with 21g, inject with a 27g.
Draw with 21g, inject with a 27g.
I thought the Op was doing the same as me.
Slin pins are 29g needles not 28 as OP said.
