• Hello, this board in now turned off and no new posting.
    Please REGISTER at Anabolic Steroid Forums, and become a member of our NEW community!
  • Check Out IronMag Labs® KSM-66 Max - Recovery and Anabolic Growth Complex

Ag-Guys Liquidex doses using dropper

redflash

Registered User
Registered
Joined
May 18, 2005
Messages
197
Reaction score
1
Points
18
Location
England
Goods received, thank you guys!

There are no markings on the dropper. I believe the dropper holds 1ml and there are 30 droppers full in each bottle. To get a dose of say 0.25mg (= a quarter of a tab), I therefore should need a quarter of a dropper-full.

Q1. If I squeeze the cap as much as possible and then draw up as much possible it appears about half-full - is this 1mg?

Q2. I guess if I want 0.25 mg I could estimate that visually but could I also count so many droplets? How many droplets per 1ml/1mg?

Once I have this sorted it will alow me to fine tune my dosages much better than with tablets where my "quarter" tabs vary quite a bit in size.

Many thanks,

Flash
 
Try backloading a syringe while counting drops to get a good guess. In the 'old days' we used to go by the Liquid Research droppers, which at 1ml were about 60 drops. Viscosity of the product and force used though could make a small difference here, since there is a certain adhesion quality even with water.

So, I'd say 12-15 drops is probably about .25cc/ml.
 
Cheers Mudge - I'll try the syringe idea but I think you're right at 12-15 drops.
 
Just go to wally world and get an oral syringe
 
If the solution is thin enough, an insulin syringe is the most accurate.
 
Back
Top