dannyg15
Registered
Just wondering if pins can be preloaded, and used at a later date. Will it affect the shelf life?
-
Hello, this board in now turned off and no new posting.
Please REGISTER at Anabolic Steroid Forums, and become a member of our NEW community!
-
Check Out IronMag Labs® KSM-66 Max - Recovery and Anabolic Growth Complex
Can pins be preloaded?
- Thread starter dannyg15
- Start date
I use to get a 3 month supply of testesterone from the pharmacy preloaded!
msumuscle
Registered
I preload most of my syringes. Like Mr.BIG said, preloading waterbased compounds is a no no. Oil based is gtg.
I preload everything. No problems so far.
I just preloaded a pin for tomorrow, 1/2ml Tren A and 1/2ml Aquabolic, the only reason I preload the Suspension is cause its mixed with oil, the Suspension clots so fast on me when it's the only gear in the syringe!
Nothing worse than sticking yourself and can't get the plunger to move, then you have to take the pin out and try to work it free, heck I had to replace the pin once, just could not get it broke free!
LightBearer
Registered
I'm just wondering, by preloading pins, isn't there a better chance of bacteria growth on the pin that may have landed on it from the air or something, then sitting around for a while
How if it's sheathed? I pull with a 20g then take that pin off and replace it with either a 23g 1 1/2" or a 25g 1" these are sheathed and still have not been exposed to air!
LightBearer
Registered
True but the oil is exposed to air when you switch pins right
EDIT: I guess the small amount of alcohol in the solvent might stop bacteria from growing
Darkcity
Registered
I would not leave it for any length of time that black rubber plunger thing does not like the alcohol and can break down in the syringe. Just my thoughts.
Again, I use to get my scrip of Test Cyp filled with preloaded syringes for 3 months in advance, never had a problem!
Ramrod11
Registered
yes
TGB1987
Registered
Yes you can preload and I do so also but some oils have a higher BA content which can break down the rubber plunger over time. This may take months or weeks it varies greatly but it can happen. I usually load my pins up for the week then put them in a zip lock bag in a shirt pocket in my closet facing down so they are not laying on the rubber plunger. In most case the rubber will not break down for a long time. Try to be sterile and I would not worry much about it.
Draw some air into the syringe right before the inject and shake it vigorously. Remove the air and shoot.
Done, worked perfectly, thank you heavy
Will this work with just a water based also?
That's what I was referring to in my previous post.
