Gear has cyrstalized. How do I bake?

[BillHicksFan]

My test vial has become cloudy and very dark on the bottom and if I shake it it gets a cloudy looking kind of tren appearance to it. I'm guessing it has crystallized and that I need to bake it to rebind the hormone.

Am I right? What's happened?

Just out of curiosity, what would happen if I were to pin it?

At what temp should I bake it and for how long?

 

[yerg]

stick a pin in it to relieve pressure, and then put it in a hot bath of water on the stove. Once the water starts to boil, turn off the heat and put the vial in the water. swirl it aroung every couple minutes.

 

[TREMBO]

I think you could add BB to the solution if the warmin doesn't works... But need more research for that or a opinion of a guy who knows more than me. I think that I've readed that in the homebrew topic, you could add like 5% of BB.

Let's see what the other guys say about it.

 

[BillHicksFan]

I shook the test yesterday and the cloudiness has improved however its gone pretty dark now. It was once as light as the test on the right.

Do you think it's still g2g?

 

[ROGUE71]

Test it on a rat! I had some that did the same thing a hot bath help but got dark as hell. I had no probs running it tho.

 

[minimal]

why does it turn dark?

 

[TREMBO]

If you don't solve the question here you can post it at the "Research Chemicals" subforum.

 

[ANIMALHAUS]

If you don't solve the question here you can post it at the "Research Chemicals" subforum.

What are you talking about?

 

[SloppyJ]

Do the hot water bath.

 

[TREMBO]

What are you talking about?

There's a section here at the IronMagazine that is called "Research Chemicals"

Research Chemicals - IronMagazine Bodybuilding Forums

 

[XYZ]

My test vial has become cloudy and very dark on the bottom and if I shake it it gets a cloudy looking kind of tren appearance to it. I'm guessing it has crystallized and that I need to bake it to rebind the hormone.

Am I right? What's happened?

Just out of curiosity, what would happen if I were to pin it?

At what temp should I bake it and for how long?

Like yerg said, put an 18g pin in the top of it, cut off the plastic tip and be sure you have a clear path through the pin. Put it in the oven at 225 degrees for 20 mins. If the homone stays in solution you're fine, if it falls out again, I would take an equal amount of grapeseed oil and add it to the gear. So if it were dosed at 200mg/ml you would have 100mg/ml after cutting it.

Once you've cut it bake it again as mentioned above, this will kill off any bacteria from the oil you added.

If after that the hormone still falls out of soultion, throw it away, it's not worth saving.

You're welcome.