• Please REGISTER at Anabolic Steroid Forums, and become a member of our NEW community!

Mixing and injecting HCG

Jlsoz

Registered
Joined
May 1, 2013
Messages
12
Reaction score
0
Points
0
Location
Houston
I'm sure this is a newbie question but want to make sure I'm thinking right.

My HCG came in a single use container which I though was strange. It came with 1ml of sodium chloride to mix in the 5000iu of HCG. I'm going to start my cycle at 500iu/wk. If broken out twice a week I would only inject 5cc correct? That seems very small. Is that right?
 
Use bacteriostatic water not the sodium chloride it comes with. You'll also need another sterile sealed empty vial. Mix 1cc bac water to dissolve the HCG. Then put that into the empty vial. Then mix 4cc bac water to that. So now every .5cc will be 500iu. Use a slin pin to inject sub q. To make it a total of 500iu a week inject 250iu (.25cc) twice a week.
 
why not just do 1 cc and then do .5 iu 2x a week? I dont get the mixing an addition 4cc of bac water.

That's a better way because you're injecting less liquid and don't need an extra vial. I think maybe be was trying to simplify it by mixing a 1:1 ratio.
 
1ml of bac water and pull to .5ius...thats point 5 not 5cc OP...
 
Use bacteriostatic water not the sodium chloride it comes with.

Why????

My 5,000iu HCG kit comes with 2ml of sodium chloride. I inject that right into the vial with powder. .2cc = 500iu. Very easy to measure out on a slin pin.
 
I'm sure this is a newbie question but want to make sure I'm thinking right.

My HCG came in a single use container which I though was strange. It came with 1ml of sodium chloride to mix in the 5000iu of HCG. I'm going to start my cycle at 500iu/wk. If broken out twice a week I would only inject 5cc correct? That seems very small. Is that right?

Are you sure it's sodium chloride? that's common table salt. or saline solution. I'd go with bac water instead. Saline solution is not easy to keep sterile from what I understand.
 
Back
Top