• Hello, this board in now turned off and no new posting.
    Please REGISTER at Anabolic Steroid Forums, and become a member of our NEW community!
  • Check Out IronMag Labs® KSM-66 Max - Recovery and Anabolic Growth Complex

pre loading shots

besoge

Registered
Joined
Dec 31, 2011
Messages
58
Reaction score
1
Points
0
Location
florida
This may sound like a dumb question but sometimes ill load all my syringes for the week up front. Would doing this have a negative impact on the hormone
 
If its just 1 week ahead then it should be fine.
Solvents used in production of aas can dissolve the rubber in the syringe, this happened to a few users but I believe they were preloading for a few weeks ahead.
 
No I dont think it would hurt the compounds but IMO you could stand a better chance of not being as sterile as if you did them on the days of the pins.
I wouldnt advise doing any more than a wk's worth though because the statement about the rubbers being deteriorated is true.
 
A week is fine, it's how I roll. BUT...just to be safe, I store the syringes upright so that the oil doesn't rest on the rubber. Also, try to leave as little amount of air in there between the rubber and the oil.





/V
 
I load my pins the night before just to save some time in the morning. Never left them loaded for any more than 12hrs or so.
 
Back
Top