IJ300 said:
I'm going add periodization to my training, and my question is do I have to change the amout of sets that I do? For example, if I do 4 sets of 5 reps of flat bench one week, then the next week do the same number of sets but do 10 reps, and for the last week keep sets at 4 again but do 15 reps. Or do I have to increase and decrease the number of sets along with the reps?
you could do it like that. That would be non-linear. You could also train your bench press twice in a week (say mon. and then on thurs.) and rotate the rep ranges in the same fashion.
You can do linear periodization:
week1-3= 12-15 (endurance)
week4-6= 8-10 (hypertrophy)
week7-9= 4-6 (strength)
Or you can load volume over a few weeks and then unload....
week1- 3sets x 5 reps
week2- 4x5 (same weight as week 1)
week3- 4x6 (try for the same weight as week1)
week4 (unload)- 2x12
and there are a lot of other options as well.
you can train chest (or everything 2x's a week) and do an acclimation/intensification cycle were you really ramp up the volume over a few weeks and then drop it down (train the bench press movement less frequenty) but increase the intensity and utalize all the fitness you have accumulated over the previous few weeks as the fatigue that was also accumulated disipates because of the lower frequency allowing for greater recovery.
You can do a 5x5 (three times a week) like a Bill Starr type of program:
day1- (medium day)- bench 5x5 (same weight)
day2- (Light day)- perform a supplpement exercise at a lighter load (ie DB bench press) OR perform bench press again at 5x5 But use 75-80% of what you used on day 1.
day3- bench 5x5 and work up to a max 5x5 set.
you could run that for a few weeks (maybe 3-4) and then drop the day 2 bench press work and turn the day 1 and day 3 work into 3x3....again, this is acclimation intensification.