what does everyone think about frontloading anybody done it had good results bad no diffrent.i would just like for my test e and eq to kick in quicker was going to do 1000mg the first week then go the rest of my cycle 500mg a week.will this help it kick inn sooner or not?
-
Hello, this board in now turned off and no new posting.
Please REGISTER at Anabolic Steroid Forums, and become a member of our NEW community!
-
Check Out IronMag Labs® KSM-66 Max - Recovery and Anabolic Growth Complex
what is yall take on frontloading?
- Thread starter BIGBEN2011
- Start date
weightslayer
Registered
read this:AAS: Short burst cycles-
that was a good read but nothing close to what i was asking.i am going to run a 14-16 week cycle front loading is taking a high dose the first week or two to suppose to help kick inn quicker.some say it works some say bs.so i was asking the people here thats in the know what they think of front loading.
hard to believe nobody talks much about frontloading on here.
weightslayer
Registered
here ya go then. i've done both...front loading and short bursts. they both work well. it all depends on the person and the goals.AAS: Front-loading steroid cycles
yea i have read those before thats where i got my idea from.i was just wondering what peoples real life results where that was from like 2007.well i am trying it i am doing 1000mg my first week and then i will drop to 500mg a week the rest the way 16 weeks.i will see i guese if it kicks in faster cause god knows we need some feed back on it on here for god sake.
GMO
Board Rep
It is a complete waste of gear IMO. I've done frontloading in the past and noticed NO difference whatsoever. You are better off using an oral like d-bol as a kicker until the test kicks in...or just be patient.
VictorZ06
Registered
I posted this not long ago.....
Front-loading steroid cycles
Posted Jul.13, 2007 under 3.4 - Steroid Cycle Planning
There is a lot of scrutiny regarding proper anabolic-androgenic steroid cycle structure for maximal muscle gains with minimal risks. Front loading is one practice gaining attention in the bodybuilding community. This process immediately elevates blood androgen levels. Front loading omits the customary delay of obtaining peak and stable blood levels by increasing the cycle???s front-end use.
Athletes stumble onto AAS use while scavenging for further ways to promote a progressive strength training routine ??? especially bodybuilders and powerlifters. Strength athletes often search for ways to develop productive steroid cycling protocols by combining the clinical research that is available with personal experience; as well as gathering insight from others. Formal clinical trials analyzing anabolic steroids in sports and exercise are rare. The medical community perceives little application for large performance-enhancing amounts of AAS to treat disease ??? even though many athletes would argue poor performance is an adverse health condition. Mostly through trial and error, numerous informal studies and private research examines various steroid cycling methods and how they can present a positive impact on performance and body composition. This information is generally shared through social networks, to include using online messaging software.
Steroid hormones meant for intramuscular injection have attached fatty (carboxylic) acid esters to delay the hormone???s actions. They create a slow-release depot within the muscle for sustained and even blood levels. Instead of being immediately metabolize, the parent hormone is steadily released for days, or weeks. The rate at which the hormone is released is based on the ester???s characteristics; such as length and weight. Commonly available heavy, long esters are: enanthate, cypionate or decanoate.
Due to a slow release, when a steroid with an attached heavy ester is injected at routine intervals, peak plasma concentrations can take weeks to elevate and remain stable. This is why most users do not notice performance results with heavy esters until a few weeks into the AAS cycle. Plasma levels must first build up to significant amounts to support the events associated with gains in strength and muscle mass. The ester???s speed of release is typically documented by it???s associated half-life, the time it takes for half of the administered steroid to metabolize. Active lives are also published, indicating the estimated time for full absorption of the compound.
Many bodybuilders and powerlifters have begun to omit the waiting period for peak blood levels with front loading. Most users report muscular gains are best made during the first several weeks of an anabolic steroid cycle; results dwindle after six to eight weeks of application. Immediately flooding the system with growth hormones makes the most of this sensitive period. Simply put: front loading gets the cycle started quicker ??? while the body is most receptive of growth cues. Also, a quicker onset can present an option for shorter cycle duration; resulting in less impact to the hypothalamic-pituitary-gonadal axis for easier post-cycle recovery of natural androgen production.
Normally, the same drug administered during the cycle is used to front load. The perfect front-load can be accurately calculated for stable release using figures and charts, but it???s cumbersome. There is some simplified guidance for front loading a heavy-ester cycle. First, calculate weekly use; administering 250 milligrams of testosterone enanthate every three days is equal to 583 milligrams per week (250/3*7). Then, double the weekly use and administer that amount prior to the first half life from the first injection ??? around four days for testosterone enanthate. Alternatively, the same compound with a lighter ester can be used, such as acetate or propionate.
Today, many users are starting to front-load steroid cycles every time a heavy ester is used ??? to eliminate delayed affects on body composition and strength. Many others merely jump start a cycle with orals or suspensions, drugs without an ester allow quick absorption. Either method will boost blood levels up quickly to fully exploit the early responsive period ??? a time when the body is primed for growth and will best use the hormonal signals for amplified muscle growth.
According to basic pharmacology, a single dose of 250mg of testosterone enanthate will deliver the parent hormone at it???s highest values the first 10 days; around 31, 27, 23, 20, 18, 15, 13, 12, 10 and nine milligrams, respectfully. After 10 days, the amounts released become negligible. Repeated injections create an overlap that gradually builds up blood levels. Actual amounts are affected by the injection site and technique, personal differences in physiology and the sites body fat levels.
The above cycle illustrates testosterone enanthate administered at 250 milligrams every three days; with and without a front load. The front loaded portion was accurately configured and applied with 500 milligrams on day one, 250 milligrams on day two, a day off and then 250 milligrams every third day for the cycle???s duration. The front load is 1000 milligrams within the first four days ??? almost twice the weekly administered amount (583mg). Blood testosterone volume is immediately elevated and reasonably stable the first week with the front load.
Non-front-loaded administration did not elevate and stabilize blood levels until over three weeks after the cycle???s launch. This is why results normally don???t manifest themselves for many weeks without a proper front load.
/V
Front-loading steroid cycles
Posted Jul.13, 2007 under 3.4 - Steroid Cycle Planning
There is a lot of scrutiny regarding proper anabolic-androgenic steroid cycle structure for maximal muscle gains with minimal risks. Front loading is one practice gaining attention in the bodybuilding community. This process immediately elevates blood androgen levels. Front loading omits the customary delay of obtaining peak and stable blood levels by increasing the cycle???s front-end use.
Athletes stumble onto AAS use while scavenging for further ways to promote a progressive strength training routine ??? especially bodybuilders and powerlifters. Strength athletes often search for ways to develop productive steroid cycling protocols by combining the clinical research that is available with personal experience; as well as gathering insight from others. Formal clinical trials analyzing anabolic steroids in sports and exercise are rare. The medical community perceives little application for large performance-enhancing amounts of AAS to treat disease ??? even though many athletes would argue poor performance is an adverse health condition. Mostly through trial and error, numerous informal studies and private research examines various steroid cycling methods and how they can present a positive impact on performance and body composition. This information is generally shared through social networks, to include using online messaging software.
Steroid hormones meant for intramuscular injection have attached fatty (carboxylic) acid esters to delay the hormone???s actions. They create a slow-release depot within the muscle for sustained and even blood levels. Instead of being immediately metabolize, the parent hormone is steadily released for days, or weeks. The rate at which the hormone is released is based on the ester???s characteristics; such as length and weight. Commonly available heavy, long esters are: enanthate, cypionate or decanoate.
Due to a slow release, when a steroid with an attached heavy ester is injected at routine intervals, peak plasma concentrations can take weeks to elevate and remain stable. This is why most users do not notice performance results with heavy esters until a few weeks into the AAS cycle. Plasma levels must first build up to significant amounts to support the events associated with gains in strength and muscle mass. The ester???s speed of release is typically documented by it???s associated half-life, the time it takes for half of the administered steroid to metabolize. Active lives are also published, indicating the estimated time for full absorption of the compound.
Many bodybuilders and powerlifters have begun to omit the waiting period for peak blood levels with front loading. Most users report muscular gains are best made during the first several weeks of an anabolic steroid cycle; results dwindle after six to eight weeks of application. Immediately flooding the system with growth hormones makes the most of this sensitive period. Simply put: front loading gets the cycle started quicker ??? while the body is most receptive of growth cues. Also, a quicker onset can present an option for shorter cycle duration; resulting in less impact to the hypothalamic-pituitary-gonadal axis for easier post-cycle recovery of natural androgen production.
Normally, the same drug administered during the cycle is used to front load. The perfect front-load can be accurately calculated for stable release using figures and charts, but it???s cumbersome. There is some simplified guidance for front loading a heavy-ester cycle. First, calculate weekly use; administering 250 milligrams of testosterone enanthate every three days is equal to 583 milligrams per week (250/3*7). Then, double the weekly use and administer that amount prior to the first half life from the first injection ??? around four days for testosterone enanthate. Alternatively, the same compound with a lighter ester can be used, such as acetate or propionate.
Today, many users are starting to front-load steroid cycles every time a heavy ester is used ??? to eliminate delayed affects on body composition and strength. Many others merely jump start a cycle with orals or suspensions, drugs without an ester allow quick absorption. Either method will boost blood levels up quickly to fully exploit the early responsive period ??? a time when the body is primed for growth and will best use the hormonal signals for amplified muscle growth.
According to basic pharmacology, a single dose of 250mg of testosterone enanthate will deliver the parent hormone at it???s highest values the first 10 days; around 31, 27, 23, 20, 18, 15, 13, 12, 10 and nine milligrams, respectfully. After 10 days, the amounts released become negligible. Repeated injections create an overlap that gradually builds up blood levels. Actual amounts are affected by the injection site and technique, personal differences in physiology and the sites body fat levels.
The above cycle illustrates testosterone enanthate administered at 250 milligrams every three days; with and without a front load. The front loaded portion was accurately configured and applied with 500 milligrams on day one, 250 milligrams on day two, a day off and then 250 milligrams every third day for the cycle???s duration. The front load is 1000 milligrams within the first four days ??? almost twice the weekly administered amount (583mg). Blood testosterone volume is immediately elevated and reasonably stable the first week with the front load.
Non-front-loaded administration did not elevate and stabilize blood levels until over three weeks after the cycle???s launch. This is why results normally don???t manifest themselves for many weeks without a proper front load.
/V
VictorZ06
Registered
Very true. I always use some prop up front along side my longer ester test. It works wonders for me, and not everyone wants to use an oral. In any case, front loading works....just take a look at the graph above.
/V
GMO
Board Rep
Graphs are cool and all, but real life...I noticed zero difference.
Yes, you can also use prop up front in lieu of an oral.
Yes, you can also use prop up front in lieu of an oral.
VictorZ06
Registered
Some think the same way bro. Some of the most senior vets here don't agree with it. I beg to differ. I've run my regular test/tren/dbol cycle many times over. I started gaining more quicker when I front loaded. I think the trick is doing it correctly...doing it wrong is a waste of gear, like you said bro.
/V
VictorZ06
Registered
Sorry for the double post....didn't see it.
/V
/V
