-
Hello, this board in now turned off and no new posting.
Please REGISTER at Anabolic Steroid Forums, and become a member of our NEW community!
-
Check Out IronMag Labs® KSM-66 Max - Recovery and Anabolic Growth Complex
Pin size
- Thread starter Hombre
- Start date
pyes
Registered
I agree with the above.....it also depends on what oil is used in the manufacturing of the compounds...not all oils have the same viscosity.
^This
pyes
Registered
that and my 25's bend sometimes....I think a 27 would snap....lol
not oil base, only water aas
pyes
Registered
not bend...it bows.
Just saying. I've never bowed/bent a pin when it was in me. I think you might be applying too much lateral pressure. Make sure you go in at 90 degrees and hold it there.
pyes
Registered
it only happens every so often...I push in real slow as i am always needle shy....and sometimes i hit nerves and my muscle jumps...and i think that is what causes it.
^^^this, i slin pin everything, no issues, actually i find its better than the 25s, even if its a 'heavier' oil.....so many ways to heat it upa bit, like rubbing the vial or syringe back n forth in your hands, slins are the way to go if you want to avoid scar tissue
GMO
Board Rep
Oils I use 23g. High dosed oils 21g. Suspensions 25g. I couldn't imagine pushing Test E through a slin pin.
this would freak me the fuck out!
BIGTIME420
Registered
I agree with MDR! Im anxious as a mofo with a 23g. I couldn't imagine sitting there for a fucking hour waiting to get 2cc into a damn 27g.
My experience doing it with a slin pin takes 10-15seconds.
Currently i have been shooting 2.5G of Test and Deca throw a 27 half inch.
Takes 10 seconds.
I heat it up on top of a radiator.
Best way to check that its ready is to have a small bubble in it.
Take the syringe turn it upside down and if the bubble rises to the opposite side really fast then its ready to go.
Its almost like water.
Currently i have been shooting 2.5G of Test and Deca throw a 27 half inch.
Takes 10 seconds.
I heat it up on top of a radiator.
Best way to check that its ready is to have a small bubble in it.
Take the syringe turn it upside down and if the bubble rises to the opposite side really fast then its ready to go.
Its almost like water.
pyes
Registered
I am lean so i get away with it.
Outside of thigh there is little to no fat.
Like darting into a slab of concrete.
Only works for
Outer thigh.
Chest
Delts
pyes
Registered
No matter how lean you are buddy, I just cant see it being deep enough. lets assume it is 1/2'' into your muscle...that still aint deep enough imo. I can see half of your oil leaking out subcutaneous and not staying in the muscle long enough....not sure if that even matters or not....lol
it definately works, imo, 1.5inch deep into the glute is the best if you are worried bout anything......but a 1/2 inch slin is fine........if it cant find the quad muscle, there is too much fat, and fat people shouldnt use gear....jmo
if you are worried about sub-q leakage, hold the needle in an extra 20sec, in the muscle, and let the oil slowly disperse
i doubted it to.....but once you start using slins, you'll never go back to anything else
I can see you point.
longs as i don't get any lumps from it i won't mind.
Got it mixed up i use the Brown 27g 5/8 Inch.
I used to use the 1inch ones but for some reason when i got to the last 3-4 mm it would get to a point where it was very painful and would always piss of blood afterwards.
Since using the 5/8 inch i can push it all the way without ever hitting that point.
pyes
Registered
yeah buddy, thats the point you want to be at.....the pain from the skin breaking...then the next pain from hitting muscle...that is where you wanna be....I think you are not hitting muscle and if you are...it is just barely.
blood pouring out is from going through a vein...not hitting deeper. You can probably get away with a 5/8....but i still think 1/2 is too small....jmo
You have been at it long enough to know what works for you (^_^)
blood pouring out is from going through a vein...not hitting deeper. You can probably get away with a 5/8....but i still think 1/2 is too small....jmo
You have been at it long enough to know what works for you (^_^)
brandon123
Registered
I bent the crap out of a 25g pin before. I was doin a shot in my quad and was almost done when my girlfriend came runnin in to the bathroom to tell me something. She spooked me and therefore I braced up by putting weight on my leg. The flexing of the muscle bent it. Talk about a weird feeling.
theBIGness
Registered
23g x 1.5
that is what I use.
I can distinctly feel two different areas when I pin. The first sting to break the surface. Then it's smooth and easy. Then I hit something a little harder and there is another little sting of pain. I believe that to be my muscle. I then go the rest of the way in painless.
This is with a 25g 1" on my quads.
This is with a 25g 1" on my quads.
Thing is i feel it going throw the skin.
Then when it goes throw the muscle.
Just this other feeling.
Once i managed to stop just as i felt it getting really akward and painful and drew blood.
Got this mindfuck each time i get to it i think i have hit a vein.
Will see how the 5/8 go.
if it don't work i got plenty of 1 and 1.5 anyway.
