Homebrewing - Need a good recipe for Test E

[Dannie]

I want to make highest possible concentration of Test E without using Ethyl Oleate as it gives me bad pip and lumps that stay for weeks (I may be allergic to it)

 

[jimm]

Bacon.. Bacon works with everythin..

It's ok you can thank me later..

 

[Tuco]

Baking soda and water, oh wait?

 

[bigbenj]

Castrol motor oil. Has to be 5w 30. Dump the powder in, shake, and inject. It's like synthol and test wrapped in one. Site enhancement for the win! Glad I could help!

 

[jackedntan]

I made some at 350 mg/ ml at 2/20 ba/bb. It leaves a lump for a couple days though if I don't mix it with something else. I'm sure someone else can make it more comfortable using a different ratio of solvents at a high concentration.

 

[bigbenj]

the research chem/home brew section would be a much better place for this.

 

[Dannie]

I made some at 350 mg/ ml at 2/20 ba/bb. It leaves a lump for a couple days though if I don't mix it with something else. I'm sure someone else can make it more comfortable using a different ratio of solvents at a high concentration.

Thanks, thats high, I think 300mg will be perfect for my needs 1.5ml e4d works out 787.5mg ew which is not too far from 800 I was planning for this cycle.

Rest of you should be banned

 

[Dannie]

the research chem/home brew section would be a much better place for this.

Haven't been here for a while, thought that research chem section is for peptides and other 'research' meds

 

[grotto72]

i've seen some brands selling 500mg/ml test. probably over 5%ba and hurt like hell.

 

[SloppyJ]

250mg

20% BB
2% BA

There is a calculator in the research section.

 

[1bad1]

Check out basskillers site bro

 

[RED-STAR]

Check out basskillers site bro

One of the best sites around

 

[collins]

dont joke about how to make this shit , u know some stupid basterd will do it

 

[aminoman74]

i realy hope you are very clean with everything you use or you will get an infection like never before.

 

[jimm]

Culs?

 

[brundel]

There is a good reason to make your gear at 200-250mg.
If your concerned with post injection pain you must understand that the higher tha mg/ml the more solvents are necessary and the more pain there will be.

2ml of 200mg/ml gear causes me no pain
1ml or 400mg gear is like getting kicked by a horse.

Your call.

 

[UA_Iron]

I think even good test E powders will hold close to 400mg/ml without any other solvents but BA @ 2%. Probably would hold that without even any BA at all.

100ml Test E @ 500mg/ml

50g Test E
2ml BA
20ml BB
30.83ml EO

You're probably in for a painful ride though...