• Hello, this board in now turned off and no new posting.
    Please REGISTER at Anabolic Steroid Forums, and become a member of our NEW community!
  • Check Out IronMag Labs® KSM-66 Max - Recovery and Anabolic Growth Complex

Sterile injection practices are a must!

cottonmouth

Registered
Joined
Apr 20, 2011
Messages
401
Reaction score
16
Points
18
Location
under the bar
So my friend just pulled 8ml of mostly blood out of his left glute, after pulling out 7ml of blood and puss yesterday. That was from a 3ml injection about 5-7 days ago.

All I have to say is holy shit. Alcohol swabs are cheap, use a ton of them, make sure you are sterile before you pin, fucking shower up. Once you see a 10ml syringe hit the spot, it will fill up as fast as you can pull the plunger. Stuff looks horrid, and it was just chilling inside of him.

He said he used alcohol swabs. But I figured he became a bit lax with it.

Just a little reminder to always follow sterile injection practices.
 
Reminds me of that video of greg valentino pulling like 30mls of nasty shit from his biceps. Of course,he was full of synthol, but jesus! Think i'll double up on the alcohol swabs after reading this.

Sent from my LG-LG730 using Tapatalk 2
 
not that unsterile injections dont cause issues..but if the gear is unsafe then all the tissue and wipes in the world wont help that...
 
Reminds me of that video of greg valentino pulling like 30mls of nasty shit from his biceps. Of course,he was full of synthol, but jesus! Think i'll double up on the alcohol swabs after reading this.

Sent from my LG-LG730 using Tapatalk 2

Exactly what I was thinking. So gross.
 
not that unsterile injections dont cause issues..but if the gear is unsafe then all the tissue and wipes in the world wont help that...

True,, But he was halfway through a 20ml vial. Another guy is running from the same brew with no problems. And he pinned the same gear on Friday with no problems.

I'm thinking he might of swabbed the vial but then forgot to swab himself, as Ive almost done that before.
 
Guys get infections from scripted test. Shit happens.
 
Alcohol swab the vial top before drawing. Than alcohol swab the injection site.
 
Muscle Gelz Transdermals
IronMag Labs Prohormones
True,, But he was halfway through a 20ml vial. Another guy is running from the same brew with no problems. And he pinned the same gear on Friday with no problems.

I'm thinking he might of swabbed the vial but then forgot to swab himself, as Ive almost done that before.

tell him not to lay the drawing pin or use pin down with the top off...even if the syringe is empty..very easy to pick up a small hair from shaving on the pin without knowing..small hairs cause big problems allot of times..
 
tell him not to lay the drawing pin or use pin down with the top off...even if the syringe is empty..very easy to pick up a small hair from shaving on the pin without knowing..small hairs cause big problems allot of times..
So true- I open the syringe package and make a "boat" out of it. Then only put covered pins in the "boat". Nothing should touch anything but the packaging. IMHO .
 
No doctor, he said he is feeling much better today though, almost no pain at all, which is down from not being able it sit or stand comfortably. lol

I did give him a walk through of what I do/ sterile practices without trying to be patronizing. He seemed to listen, but I guess only time will tell. I believe it gave him a good scare, so hopefully he wont be in this mess again.

Man I should of taken pics of the syringes full of the stuff..
 
not that unsterile injections dont cause issues..but if the gear is unsafe then all the tissue and wipes in the world wont help that...

Exactly what I was thinking. Infections are due much more frequently to dirty gear than not sterilizing the injection site.

I should not be saying this on the open boards, as it does not set a good example and goes against what I have preached, but I have NEVER used alcohol on an injection site in my entire life...not even once. In fact, I have never even cleand the area. I have never had a single problem. Of course, none of my injection sites are ever exposed to the outside, but are always covered with clothes...which significantly cuts down on the possibility of getting anything on my skin which could cause an infection. Now, I would not inject into an area which was obviously dirty, but if I have taken a shower and/or the area has been covered since the previous shower, the chances of getting bacteria into the body capable of causing a serious infection are very low.

Dirty gear presents a far greater cause for concern.
 
Exactly what I was thinking. Infections are due much more frequently to dirty gear than not sterilizing the injection site.

I should not be saying this on the open boards, as it does not set a good example and goes against what I have preached, but I have NEVER used alcohol on an injection site in my entire life...not even once. In fact, I have never even cleand the area. I have never had a single problem. Of course, none of my injection sites are ever exposed to the outside, but are always covered with clothes...which significantly cuts down on the possibility of getting anything on my skin which could cause an infection. Now, I would not inject into an area which was obviously dirty, but if I have taken a shower and/or the area has been covered since the previous shower, the chances of getting bacteria into the body capable of causing a serious infection are very low.

Dirty gear presents a far greater cause for concern.
Holy shit Mike ! You are so lucky you never got Cellulitis, a skin infection . I'm unlucky, had it twice with wipes ?
 
I pulled 5 cc of puss out of my shoulder once. the fucking smell was unbelievable. it was water based winny and I will never touch a water based product again...

I also should note that I think its of critical importance to shot is a clean enviroment to. I always shoot in the bathroom and I clean it top to bottom twice a week. on a side women love clean bathrooms. just sayin
 
So true- I open the syringe package and make a "boat" out of it. Then only put covered pins in the "boat". Nothing should touch anything but the packaging. IMHO .

That's a damned good idea. Gonna try it. I keep my bathroom surfaces as frequently clean as I can but... it's a losing game really, given the bacterial sources it's exposed to.
 
I pulled 5 cc of puss out of my shoulder once. the fucking smell was unbelievable. it was water based winny and I will never touch a water based product again...

I also should note that I think its of critical importance to shot is a clean enviroment to. I always shoot in the bathroom and I clean it top to bottom twice a week. on a side women love clean bathrooms. just sayin

See bold above: Truth.
 
Holy shit Mike ! You are so lucky you never got Cellulitis, a skin infection . I'm unlucky, had it twice with wipes ?

Damn...I forgot about that. I did get that before from dirty gear...got it 4 times from 4 different vials of the same gear (all Dihydroboldenone from the same manufacturer). This was 6 years ago and the only problem I ever had. I have never had an infection, but the cellulitis was from bad gear...not unsanitary injection habits.
 
Back
Top